Cyclotube Model CI Dust Collector CI series CI series

Standard Features The Airex Industries Model CI Dust Collector is ideally suited for schools or small industrial applications where large volume or air are required for relatively small amounts of dust collected. This unit is primarily designed for limited ceiling height installations. The CI model unit is divided into four basic sections, the top section being the storage containers for the collected waste material. The centre two sections are the primary and secondary filtration units. The material enters the unit via the inlet duct into the cyclonic separation section to remove the heavy particles. The section immediately above it is the secondary filtration area, where tubular type filters are used with various filter media available for various applications. This gives a highly efficient type of dust collection system. The material storage area and the secondary filtration section are accessible through large access doors that allow for easy material removal and filter maintenance of the unit. The Model CI is part of the CE series of dust collectors and designed by Airex Industries in which standardized construction methods and parts are used to create a highly efficient unit and still maintain a low cost. The unit requires a minimum of maintenance. All parts which must be maintained are easily accessible. The unit is supplied ready to operate, requiring only connection to a power source through a starter and into the unit. The unit is ruggedly constructed and has a very convenient material storage and removal all packaged into a single completely self-contained unit. Air to cloth ratios can be changed for extremely difficult types of material handling although the standard unit is designed for maximum efficiency in most woodworking applications. Hopper storage section is available for certain installations and automatic shaking mechanisms are available for your secondary filtration section. Options Silencer : The unit has a very low noise level an even quieter performance may be required inline silencer. Low ceiling modification : Dust collector can be modified to fit into restricted ceiling height areas by having the fan and motor mounted alongside of the collector on a stand or on the ground. Filter media : Although the unit with standard filter media is designed to handle almost any type of dust problem, a number of special filter medias and/or air to cloth ratios are available for the more unusual type of dust problems. Automatic shaker : The automatic shaker is electrically driven with a timing device which is energized when the fan is stopped. The shaker operates for a predetermined length of time. Dirty filter indicator : Magnehelic gauge which automatically indicates when filter media required shaking down. Cone styled discharge : For continuous discharge through a rotary air lock. Explosion venting : To meet NFPA requirements please check with Airex Industries. Features Highly efficient performance; It fits into low ceiling areas, yet takes up minimal amount of floor space. It can be installed inside a building as well as outside. Quiet operation. Easy to empty the collected waste. Flexible in design and capacities to fit all types of operations. Practically no maintenance. Manual shaking mechanism (standard equipment). High performance on all types of dust particles. Easy operation. Shipped completely assembled. Flexible cfm ratings for top performance. Primary cyclonic separator. Secondary bag type filtration.